Hélas non! sudo ifup eth1 me donne ceci:
Starting wpa_supplicant: wpa_supplicant v0.4.5
Copyright (c) 2003-2005, Jouni Malinen <jkmaline@cc.hut.fi> and contributors
This program is free software. You can distribute it and/or modify it
under the terms of the GNU General Public License version 2.
Alternatively, this software may be distributed under the terms of the
BSD license. See README and COPYING for more details.
This product includes software developed by the OpenSSL Project
for use in the OpenSSL Toolkit (http://www.openssl.org/)
usage:
wpa_supplicant [-BddehLqqvwW] -i<ifname> -c<config file> [-D<driver>] \
[-P<pid file>] [-N -i<ifname> -c<conf> [-D<driver>] ...]
drivers:
hostap = Host AP driver (Intersil Prism2/2.5/3)
prism54 = Prism54.org driver (Intersil Prism GT/Duette/Indigo)
madwifi = MADWIFI 802.11 support (Atheros, etc.)
atmel = ATMEL AT76C5XXx (USB, PCMCIA)
wext = Linux wireless extensions (generic)
ndiswrapper = Linux ndiswrapper
ipw = Intel ipw2100/2200 driver
wired = wpa_supplicant wired Ethernet driver
options:
-B = run daemon in the background
-d = increase debugging verbosity (-dd even more)
-K = include keys (passwords, etc.) in debug output
-t = include timestamp in debug messages
-h = show this help text
-L = show license (GPL and BSD)
-q = decrease debugging verbosity (-qq even less)
-v = show version
-w = wait for interface to be added, if needed
-W = wait for a control interface monitor before starting
-N = start describing new interface
No configuration found.
Failed to bring up eth1.
je me demandais si ce n'est pas mes "manipulations" précédentes avec nfdiswrapper qui pose problème. J'en doute car cela n'a pas abouti.
iwconfig après redémarrage me donne
eth1 unassociated ESSID
ff/any Nickname:"ipw2100"
Mode:Managed Channel=0 Access Point: 00:00:00:00:00:00
Bit Rate=0 kb/s Tx-Power
ff
Retry min limit:7 RTS thr
ff Fragment thr
ff
Power Management
ff
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
à noter que le led bleu de mon wlan ne s'allume pas après redémarrage, je dois l'activer par fn+f2.
Serais-ce le "noacpi" ou je sais plus quoi, "acpi=off" que j'ai entré à l'install de Kubuntu qui pose problème?
Merci encore de ton assistance . J'espère qu'on va y arriver.