ma config : CM MSI K7N2delta-l, CG asus GeForce MMX440
OS : slackware 10.0
bonjour,

je viens d'acquérir une carte TV "Leadtek Winfast Tv 2000 XP Deluxe"
elle bien reconnue au niveau matériel :

bttv0: i2cbttv: driver version 0.9.15 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
bttv0: Bt878 (rev 17) at 0000:01:07.0, irq: 5, latency: 32, mmio: 0xe8000000
bttv0: detected: Leadtek WinFast TV 2000 [card=34], PCI subsystem ID is 107d:6606
bttv0: using: Leadtek WinFast 2000/ WinFast 2000 XP [card=34,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=003ff500 [init]
bttv0: using tuner=5
: checking for MSP34xx @ 0x80... not found
bttv0: i2c: checking for TDA9875 @ 0xb0... not found
bttv0: i2c: checking for TDA7432 @ 0x8a... not found
tuner: Ignoring new-style parameters in presence of obsolete ones
tuner: chip found at addr 0xc2 i2c-bus bt878 #0 [sw]
tuner: type set to 5 (Philips PAL_BG (FI1216 and compatibles)) by bt878 #0 [sw]
bttv0: registered device video1
bttv0: registered device vbi0
bttv0: registered device radio0
bttv0: PLL: 28636363 => 35468950 .. ok
bttv0: add subdevice "remote0"

et puis j'arrive pas à afficher une image,
en secam/pal c'est que du bruit, comme si aucun signal

pourtant le cable télé fonctionne
je ne vois pas ce qui déconne

Poste le Sunday 16 January 2005 01:27:11