Léa-Linux & amis :   LinuxFR   GCU-Squad   Zarb.Org   GNU
Archive de la liste aide - [Aide] [aide]monter 2 périphériques usb sous Debian
Bonsoir la liste,

J'essaie de [sujet], et ça ne fonctionne pas.

Le 1er pas de souci, parcontre le 2eme ne veut rien savoir, il prend 
l'alim électrique, et "parle" avec udisks et se présente, mais udisks le 
refuse et il ne se passe rien d'autre dans Nautilus ou la barre des 
disques montés.

Quelques recherches sur la toile n'ont rien ramené de convenant à la 
situation, (comme dirait Jean-Claude)))

Précision, les 2 périph usb fonctionnent si branchés seul, c'est le 2eme 
simultané qui reste "muet", quel que soit l'ordre de branchement.

Si quelq'un-e avait une idée ??

D'avance merci, voici la partie de dmesg qui concerne 'l'affaire', on 
voit bien que le 1er est ok :


usb 1-5: new high-speed USB device number 2 using ehci_hcd
[  102.232855] usb 1-5: New USB device found, idVendor=071b, idProduct=3203
[  102.232860] usb 1-5: New USB device strings: Mfr=1, Product=2, 
SerialNumber=3
[  102.232863] usb 1-5: Product: ROCK MP3
[  102.232866] usb 1-5: Manufacturer: RockChip
[  102.232868] usb 1-5: SerialNumber: USBV1.00
[  102.347968] Initializing USB Mass Storage driver...
[  102.348281] usb-storage 1-5:1.0: Quirks match for vid 071b pid 3203: 400
[  102.348306] scsi4 : usb-storage 1-5:1.0
[  102.348436] usbcore: registered new interface driver usb-storage
[  102.348439] USB Mass Storage support registered.
[  105.381123] scsi 4:0:0:0: Direct-Access     RockChip USB MP3          
1.00 PQ: 0 ANSI: 0
[  105.381594] scsi 4:0:0:1: Direct-Access     RockChip USB 
SD               PQ: 0 ANSI: 0 CCS
[  105.384353] sd 4:0:0:0: Attached scsi generic sg4 type 0
[  105.386124] sd 4:0:0:1: Attached scsi generic sg5 type 0
[  105.388618] sd 4:0:0:0: [sdc] 7979008 512-byte logical blocks: (4.08 
GB/3.80 GiB)
[  105.389233] sd 4:0:0:1: [sdd] Attached SCSI removable disk
[  105.389730] sd 4:0:0:0: [sdc] Write Protect is off
[  105.389736] sd 4:0:0:0: [sdc] Mode Sense: 03 00 00 00
[  105.390233] sd 4:0:0:0: [sdc] No Caching mode page found
[  105.390240] sd 4:0:0:0: [sdc] Assuming drive cache: write through
[  105.393847] sd 4:0:0:0: [sdc] No Caching mode page found
[  105.393854] sd 4:0:0:0: [sdc] Assuming drive cache: write through
[  105.394776]  sdc: sdc1
[  105.398198] sd 4:0:0:0: [sdc] No Caching mode page found
[  105.398206] sd 4:0:0:0: [sdc] Assuming drive cache: write through
[  105.398211] sd 4:0:0:0: [sdc] Attached SCSI removable disk
[  105.968666] FAT-fs (sdc1): utf8 is not a recommended IO charset for 
FAT filesystems, filesystem will be case sensitive!
[  127.832025] usb 1-6: new high-speed USB device number 3 using ehci_hcd
[  127.965689] usb 1-6: New USB device found, idVendor=0bc2, idProduct=3320
[  127.965695] usb 1-6: New USB device strings: Mfr=2, Product=3, 
SerialNumber=1
[  127.965698] usb 1-6: Product: Expansion Desk
[  127.965701] usb 1-6: Manufacturer: Seagate
[  127.965704] usb 1-6: SerialNumber: NA4M1HT5
[  127.966919] scsi5 : usb-storage 1-6:1.0
[  128.964800] scsi 5:0:0:0: Direct-Access     Seagate  Expansion Desk   
0711 PQ: 0 ANSI: 6
[  128.967699] sd 5:0:0:0: Attached scsi generic sg6 type 0
[  128.973675] sd 5:0:0:0: [sde] Spinning up disk.............ready
[  139.020628] sd 5:0:0:0: [sde] 3907029167 512-byte logical blocks: 
(2.00 TB/1.81 TiB)
[  139.030881] sd 5:0:0:0: [sde] Write Protect is off
[  139.030887] sd 5:0:0:0: [sde] Mode Sense: 4f 00 00 00
[  139.031617] sd 5:0:0:0: [sde] Write cache: enabled, read cache: 
enabled, doesn't support DPO or FUA
[  139.160022] usb 1-6: reset high-speed USB device number 3 using ehci_hcd
[  139.424020] usb 1-6: reset high-speed USB device number 3 using ehci_hcd
[  139.597120] usb 1-6: device firmware changed
[  139.597143] usb 1-6: USB disconnect, device number 3
[  139.604036] sd 5:0:0:0: [sde] Unhandled error code
[  139.604042] sd 5:0:0:0: [sde]  Result: hostbyte=DID_NO_CONNECT 
driverbyte=DRIVER_OK
[  139.604047] sd 5:0:0:0: [sde] CDB: Read(10): 28 00 00 00 00 00 00 00 
01 00
[  139.604060] end_request: I/O error, dev sde, sector 0
[  139.604066] Buffer I/O error on device sde, logical block 0
[  139.604101] sd 5:0:0:0: [sde] Unhandled error code
[  139.604104] sd 5:0:0:0: [sde]  Result: hostbyte=DID_NO_CONNECT 
driverbyte=DRIVER_OK
[  139.604109] sd 5:0:0:0: [sde] CDB: Read(10): 28 00 00 00 00 01 00 00 
01 00
[  139.604118] end_request: I/O error, dev sde, sector 1
[  139.604122] Buffer I/O error on device sde, logical block 1
[  139.604293] ldm_validate_partition_table(): Disk read failed.
[  139.604433] Dev sde: unable to read RDB block 0
[  139.604615]  sde: unable to read partition table
[  139.605653] sd 5:0:0:0: [sde] READ CAPACITY failed
[  139.605658] sd 5:0:0:0: [sde]  Result: hostbyte=DID_NO_CONNECT 
driverbyte=DRIVER_OK
[  139.605664] sd 5:0:0:0: [sde] Sense not available.
[  139.605696] sd 5:0:0:0: [sde] Asking for cache data failed
[  139.605700] sd 5:0:0:0: [sde] Assuming drive cache: write through
[  139.605704] sd 5:0:0:0: [sde] Attached SCSI disk
[  139.720025] usb 1-6: new high-speed USB device number 4 using ehci_hcd
[  139.853830] usb 1-6: New USB device found, idVendor=0bc2, idProduct=3320
[  139.853835] usb 1-6: New USB device strings: Mfr=2, Product=3, 
SerialNumber=1
[  139.853838] usb 1-6: Product: Expansion Desk
[  139.853841] usb 1-6: Manufacturer: Seagate
[  139.853844] usb 1-6: SerialNumber: 16BF332755FY
[  139.854486] scsi6 : usb-storage 1-6:1.0
[  140.852820] scsi 6:0:0:0: Direct-Access     Seagate  Expansion Desk   
0711 PQ: 0 ANSI: 6
[  140.855703] sd 6:0:0:0: Attached scsi generic sg6 type 0
[  140.858437] sd 6:0:0:0: [sde] Spinning up disk..............
[  182.992023] usb 1-6: reset high-speed USB device number 4 using ehci_hcd
[  184.132014] 
..........................................................not responding...
[  241.368414] sd 6:0:0:0: [sde] 3907029167 512-byte logical blocks: 
(2.00 TB/1.81 TiB)
[  248.293276] sd 6:0:0:0: [sde] Test WP failed, assume Write Enabled
[  255.243093] sd 6:0:0:0: [sde] Asking for cache data failed
[  255.243101] sd 6:0:0:0: [sde] Assuming drive cache: write through
[  255.247206] sd 6:0:0:0: [sde] Spinning up disk........................
[  307.120023] usb 1-6: reset high-speed USB device number 4 using ehci_hcd
[  308.260012] ......................
[  360.144047] usb 1-6: reset high-speed USB device number 4 using ehci_hcd
[  361.284012] .not responding...
[  368.189533] sd 6:0:0:0: [sde] Test WP failed, assume Write Enabled
[  375.139235] sd 6:0:0:0: [sde] Asking for cache data failed
[  375.139243] sd 6:0:0:0: [sde] Assuming drive cache: write through
[  475.216022] usb 1-6: reset high-speed USB device number 4 using ehci_hcd

-- 
Fred


Serveur hébergé par ST-Hebergement et Lost-Oasis / IRC hébergé par FreeNode / NS secondaire hébergé par XName
Sauf mention contraire, les documentations publiées sont sous licence Creative-Commons