Je viens de graver un sous linux...y a aussi 680 705 102 octets et ça boot ...mais je sais pas si utilisable intégralement car y a une erreur à 4"% lors de gravage..qq'1 a une idée de quoi s'agit-il ?
root@SlackW:/home/bob# cdrecord -v -speed=40 -dev=1,0,0 -data /home/bob/slackware-10.0-install-d1.iso
Cdrecord 2.0 (i686-pc-linux-gnu) Copyright (C) 1995-2002 Jörg Schilling
TOC Type: 1 = CD-ROM
scsidev: '1,0,0'
scsibus: 1 target: 0 lun: 0
Linux sg driver version: 3.1.24
Using libscg version 'schily-0.7'
atapi: 1
Device type : Removable CD-ROM
Version : 2
Response Format: 1
Vendor_info : ' '
Identifikation : 'BPN-KM52X16 '
Revision : '1.83'
Device seems to be: Generic mmc2 DVD-ROM.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1951488 = 1905 KB
FIFO size : 4194304 = 4096 KB
Track 01: data 651 MB
Total size: 747 MB (74:05.46) = 333410 sectors
Lout start: 748 MB (74:07/35) = 333410 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 5
Is not unrestricted
Is not erasable
Disk sub type: Medium Type A, high Beta category (A+) (3)
ATIP start of lead in: -11634 (97:26/66)
ATIP start of lead out: 359846 (79:59/71)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 3
Manufacturer: CMC Magnetics Corporation
Blocks total: 359846 Blocks current: 359846 Blocks remaining: 26436
Starting to write CD/DVD at speed 40 in real TAO mode for single session.
Last chance to quit, starting real write 0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is OFF.
Performing OPC...
Starting new track at sector: 0
Track 01: 249 of 651 MB written (fifo 100%) [buf 43%] 3.5x.cdrecord: Input/output error. write_g1: scsi sendcmd: no error
CDB: 2A 00 00 01 F3 07 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 71 00 03 00 00 00 00 0A 00 00 00 00 0C 00 00 00
Sense Key: 0x3 Medium Error, deferred error, Segment 0
Sense Code: 0x0C Qual 0x00 (write error) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.769s timeout 40s
write track data: error after 261634048 bytes
Sense Bytes: 70 00 00 00 00 00 00 0A 00 00 00 00 00 00 00 00 00 00
Writing time: 488.987s
Average write speed 9.3x.
Min drive buffer fill was 2%
Total of 13 possible drive buffer underruns predicted.
Fixating...
Fixating time: 153.852s
cdrecord: fifo had 4185 puts and 4122 gets.
cdrecord: fifo was 0 times empty and 4121 times full, min fill was 98%.
Poste le Sunday 4 July 2004 20:22:50